Recent content by clibra

The engine is still under designing ? Are you serious? 😅 To design, manufacture, verify&test a engine for Gen-4 fighter, a country need to invest multi billion usd, 10,000(if not more) technical manpower, and decades of time. good luck! 😅

don't waste your time, it's no good doing that.

你还是别白费劲了，毫无意义，还被人骂。🤣

Bro, Pakistan already spent bulk of its money/manpower/resources into sections you mentioned above, a country can do limit things given limit resource.

And WS-20 is slightly better than PS-90 in performance. 2025

Russian NAVY purchased engines from China to equip their battle ships.

man r you really from India? 😂😂

American are very close to 6th generation jets induction ? I don't think so. China's 6th gen. development is not slow at all. If there's a single WS-15 fighter project exist, I think it'll be Gen. 5.5, and will finally evolve to 6th Gen(low end). And there should be a high-end 6th gen. with...

You can always trust CAC on quality. They work very hart to improve their manufacture capability to the state of art level.

If ESSM size SAM were developed, it's must be 4-in-1 cell, the total missile amount can increase significantly, so no need to increase VLS to 128.

Looks fancy but this is still a sub-stealth fighter, about Gen. 4.75. CAC need to develop a fully stealth Gen. 5 fighter based on WS-15 advanced engine. It's reasonable that a high BPR version of WS-15(like F-135) can achieve 18 ton+ thrust, which can support a 30t MTOW fighter, similar as F35C.

me 2

9 seconds? please be more specific on the beginning point and ending point in the video.

Please provide your calculation details of your 30/21 deg/sec results. Don't tell me you did a simulation in your brain. :cheesy: Don't tell me "I don't konw why but I just believe turn rate of J20 can not be better than mig29/gripen/F16" :D